Alright so I finally picked up my MOBO and CPU today.
I went with an Athlon II x4 620 for $108.99 and MSI 790X-G45 ATX AM3 Crossfire Motherboard for $89.99. Both are just average mobo + CPU compared to what is out there in todays market, but its good enough for me. When installing the CPU, you have to lift the safety arm, and then just drop the damn thing in. Afterwards close the safety arm and put the stock cooling on (no tube lube needed because the retail stock cooler already has the thermal compound on it). The mobo just screw the damn thing in but make sure you screw in the board lifts !! (i forgot one and the board was slanted =P).
I also replaced the yale loons rear fan i had with another one with higher CFM. I think the old fan might have a faulty bearing because i noticed it wiggles a bit when it rotates and didn't push that much air out (strange). If you see closely, i replaced the red fan with the blue one =D
So Everything is in, i plug in the case plugs (Power switch, Power led and Reset Switch. It has no HDD led lawl. Cheap case). The ATX 24 pin PSU cable to the Mobo is in and the sata cables for the dvd drive and hdd are in too.
Go to turn the facker on. Shit the fackers on !!! The usb power works, mobo board lights up, fans go, CPU fan goes and I go check the VGA slot on the back.......
FACKKKKK. Its a facking Female connection !! Most (almost all i see) were male VGA connectors on the back. This one is female? Wtf. So i got to buy a 12 dollar cable now D=. Since i want to save 12 bucks, i put in this cheap PCI graphics card that i ripped from my old computer.
So i try to test it instead by putting in this shitty 8400 gt PCI graphics card that came with my old comp (not PCI-e....PCI lawl) to check out the bios. I shove it in the PCI slot. The Video card fan goes, i hear it vrumming (so i know the mobo is working at least judging by the phase lights, turn on response, usb power, cpu fan, and pci voltage). Plug the VGA male to male cable in andddd.............nothingg. After an hr of going "WTH mate", I find out that I forgot to put in the 4 pin power cord next to the CPU D=.......
Okay and lastly I have to show you my fan layout. The intake fans have higher CFM than the output. So in the end more intake is occuring than output by around 10 CFM. I would say it is pretty even.
I also used Thundercunt's Fan layout as a reference. Thanks thundercunt =)
8 Comments
Recommended Comments