Jump to content
  • 0
Sign in to follow this  
Olykiller

some problems

Question

Yo FA

 

Today i went on FA1 and saw my admin and xp was all gone, any reason?

also have major lags both on jaymod as etpro, no fps lag, just ultrahigh ping (lagometer has green pikes)

 

only thing i did was change my etpro cfg and etmain cfg back to my old one, but that has nothing to do with this right?

 

Oly

 

E: ss of lag

post-868-0-44189200-1334658197_thumb.jpg

Edited by Olykiller

Share this post


Link to post
Share on other sites

4 answers to this question

Recommended Posts

  • 0

Admin lvl and xp points = etkey issue, below solution.

Your another cfg might not have these commands set properly.

Set these command to the given values

 

/pb_cl_enable 1

/pb_system 1

/pb_writecfg 1

/reconnect

 

About the ping, hmm what's Your /rate , cl_maxpackets ?

Share this post


Link to post
Share on other sites
  • 0

on etrpo:

rate 25 000

maxpackets 100

 

jaymod

rate around 32 000

maxpackets 100

 

about those settings, none of them are in my cfg but do they have effect? since pb no longer supports ET right? anyway ill try them!

 

E: had those setting already in jaymod cfg

 

E2: got my admin lvl back thx to the cmd's you gave, only xp is still gone but dont care about that. Though i still have huge lag

 

E3: admin suddenly gone, dont understand anything anymore :(

Edited by Olykiller

Share this post


Link to post
Share on other sites
  • 0

for the level, if you play with tzac, that could turn off pb, if you start et with +set cl_punkbuster 1 when you play jaymod then you should have pb on, and the level (or you can do /pb_cl_enable as an alternative)

 

as regards the lags, I am not aware of any setting that can cause such a huge lag, you should check your ping outside the game with winmtr, imho your internet lags

Share this post


Link to post
Share on other sites
  • 0

i play ETpro with TZAC yes

but i start jaymod with ET.exe

 

also my xp doesnt restore anymore but i do have an etkey in etmain map!

when i start jaymod pb doesnt 'load' automatically, i need to do /pb_cl_enable and /pb_system by myself

ive no autoexec cfg if that matters, only etmain, etpro, jaymod

 

prolly ur right about my internet, could be the neighbours

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×

Important Information

By using this site, you agree to our Terms of Use.