Search the Community
Showing results for tags '110v'.
Found 1 result
-
Thought I'd run this past you guys. Bought a house last year, Cctober 7th 2016. A tree fell on my house in February 2017. (110v wires are in attic crawlspace). No electrical problems until about three weeks ago. It seems to be limited to my office. I have wiring experience. I'm wondering whether I should hire an electrician, an inspector, or complain to my energy company. Mains voltage: 118v during the day, 114.5v during the night (barebones minimum, I know) in my office. Around three weeks ago, there was a sudden brownout. (Not used to this being on Seattle City Light) Lights dimmed once- thought nothing of it. Lights came back to normal- and dimmed once again. Computer shut down- signifying a voltage drop below 110v. Called my new power company (Puget Sound Energy), and they denied any problem. Told me I had a loose 110 Neutral wire in my breaker box, because my 220 appliances worked fine. Since it was momentary, I called bullshit on their excuse. Sure enough, my Kill-A-Watt showed 113- compared to the normal 117v. Checked the outage map after the call- Over 1,300 people were without power in my area. Tonight, my power in my office went out again. There are over 7,000 reported outages, but none in my area. I noticed the lights dimmed while I was outside on the phone with 911 reporting a domestic disturbance. I was chatting with Carbonautics on Steam before I stepped out. When I came back in, the power was on, but my computer was off. I was going to call my power company until I noticed... another computer of mine on a different circuit had 13days uptime. It uses less power... but it made me wonder. I have rewired the telecommunications but not the electrics. It is dated between 1967 and 1980. There are no signs of severe circuit overload (buzzing- or "BONG" noise signifying a wire bouncing or harmonically vibrating ). I have a two-pole circuit box. 110v (for mains voltage) and 220v (for range/oven and dryer). The 220v circuits are dedicated, and the 110v are "cheater circuits". However, my office is the only one on the circuit using power- and less than 5 amps. I noticed that the old outlets in my house were wearing out when I bought the place, so I replaced them. The old outlets had ground wires resting on the outlet box, I made sure to use a direct connection with drip-loop to every outlet- hoping to eliminate arc-fault scenarios. It seemed to work great. But now, a year later... I'm wondering if I made a mistake somewhere. I know daisy-chain circuits and cheater breakers are frowned upon, but they've worked well for a year. I really don't use that much power. I guess my question is whether you think my power company or my wiring is at fault. I believe it is my power company, but it seems like my brownouts are limited to my office (though it does use the most current), and as such I wonder if I made a wiring fault.
